VERTICAL |
| Channels | 4 |
| Bandwidth | DC ~ 200MHz (-3dB) |
| Rise Time | 1.75ns Approx. |
| Sensitivity | 2mV/div ~ 5V/div (1-2-5 increments) |
Accuracy
| ∮(3% x |Readout|+0.05 div x Volts/div+0.8mV) |
| Input Coupling | AC, DC & Ground |
Input Impedance
| 1M∮2%, ~16pF |
| Polarity | Normal & Invert |
Maximum Input
| 300V (DC+AC peak), CATII |
| Waveform Signal Process | + , - , FFT |
Offset Range
| 2mV/div ~ 20mV/div : 0.5V ; 50mV/div ~ 200mV/div : 5V ; 500mV/div ~ 2V/div : 50V ; 5V/div : 300V |
| Bandwidth Limit | 20MHz (-3dB) |
TRIGGER |
| Sources | CH1 , CH2 , CH3 , CH4 , Line |
Modes
| Auto-Level, AUTO, NORMAL, SINGLE, TV, Edge |
| Coupling | AC , DC , LF rej. , HF rej. , Noise rej. |
| Sensitivity | DC ~ 25MHz : Approx. 0.5div or 5mV
25MHz ~ 200MHz : Approx. 1div or 10mV |
HORIZONTAL |
| Range | 1ns/div ~ 10s/div (1-2-5 increments); ROLL : 250ms/div ~ 10s/div |
| Modes | MAIN, WINDOW, WINDOW ZOOM, ROLL, SCAN, X-Y |
| Accuracy | ∮0.01% |
| Pre-Trigger | 20 div maximum |
| Post-Trigger | 1000 div |
X-Y MODE |
| X-Axis Input | Channel 1 |
Y-Axis Input
| Channel 2 |
| Phase Shift | ∮3 at 100kHz |
SIGNAL ACQUISITION
|
| Real-Time Sample Rate | 1GSa/s maximum |
Equivalent Sample Rate
| 25GSa/s maximum |
| Vertical Resolution | 8 Bits |
| Record Length | 25K Dots maximum |
Acquisition Mode
| Normal, Peak Detect, Average |
Peak Detection
| 10ns |
Average
| 2 , 4 , 8 , 16 , 32 , 64 , 128 , 256 |
CURSORS AND MEASUREMENT |
| Voltage Measurement | Vpp , Vamp , V avg , Vrms , Vhi , Vlo , Vmax , Vmin , Rise Preshoot/ Overshoot , Fall Preshoot/Overshoot |
| Time Measurement | Freq , Period , Rise Time , Fall Time , Positive Width , NegativeWidth , Duty Cycle |
Delay Measurement
| Eight different delay measurement |
| Cursors Measurement | Voltage difference between cursors (V) Time difference between cursors (T) |
Auto Counter
| Resolution : 6 digits
Accuracy : ∮2%
Signal Source: All available trigger source except the Video trigger mode |
CONTROL PANEL FUNCTION
|
| Autoset | Adjust Vertical VOLT/DIV, Horizontal TIME/DIV, and Trigger level automatically |
| Save Setup | Up to 20 sets of measurement conditions |
Save Waveform
| 24 sets of waveform |
DISPLAY
|
| TFT LCD Type | 5.6 inch |
Display Resolution
| 234 (Vertically) x 320 (Horizontally) Dots |
Display Graticule
| 8 x 10 divisions ; 8 x 12 divisions (menu off) |
Display Brightness
| Adjustable |
INTERFACE
|
| Go/NoGo Output | 5V Maximum/10mA TTL Open Collector Output |
| RS-232 Interface | DB 9-pin male DTE RS-232 interface |
| GPIB Interface (Option) | Fully programmable with IEEE 488.2 compliance |
| USB | USB Host/Device 2.0 full speed supported |
POWER SOURCE
|
Line Voltage Range
| AC 100V ~ 240V , 48Hz ~ 63Hz , Auto selection |
Battery Power(Option)
| Battery : 11.1V Li-Ion battery pack
Charge Time : 8 hours (Power ON)
Operating Time : 3 hours , depending on operating condition |
MISCELLANEOUS
|
Multi-Language Menu
| Available |
| Online Help | Available |
| Time Clock | Time and Date, Provide the Date/Time for saved data |
| DIMENSIONS &WEIGHT | 254D x 142H x 310W(mm)
Approx. 4.3kg |
